Also make sure you have midi patterns in your Addictive Drums instrument track. If not, make sure nothing is on mute in your plugin. At this time, if you run your playback, everything should be working. Just click on the desired source to define the input signal. We do however recommend that you use Addictive Drums 2 in one of the DAWs or hosts that we officially support. When your tracks are created, select the input menu for one of them, then, click on Plug-in, Addictive Drumss, and you will see all the buses from your virtual drum. How to load Addictive Drums 2 as a plug-in XLN Audio Support How to load Addictive Drums 2 as a plug-in Addictive Drums 2 can be loaded as an instrument plug-in in most DAWs and hosts with VST, AU or AAX support. If you use audio tracks, make sure you enable the recording buttons, located over the Pan button, to activate the input signal. I recommend to use auxiliary or bus tracks and to keep your plugin active, in order to maintain access to the internal settings until you are done working on it. Make sure to create 10 mono and 3 stereo tracks. The signal is mono when it comes from a single source like the kick or the snare and stereo when it comes from the overhead, room microphone or parallel compression. You have to create tracks in you DAW mixer to receive the Addictive Drums signal. Once the arrow is green, Addictive Drums automatically creates a send bus to your recording software. Click on Pre Fader if you want to bypass the internal mixer settings, or Post Fader if you want to keep them. You will see the different output options. Open Addictive Drums and click on the small arrow at the bottom of the mixer panel of any drum track.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |